The OE Subaru boost control setup is not as good as it could be so when wanting to increase the boost and gain better control of the turbo actuator a 3 port boost control solenoid is really worth fitting. ScoobyWorx sell a known good 3 port solenoid with the correct plug adapter meaning I wouldn’t […]
An important part of getting the most power out of the EJ255 in the Forester STI is improving exhaust flow. The factory catalytic converter (cat) is quite a restriction on flow and it being right at the outlet of the turbo will really reduce the speed the exhaust gas can flow through the exhaust turbine […]
The factory inlet to the air box draws air from just behind the headlight down into a Y piece with a large air box underneath then back up into the filter box. The STI fog light covers have a useful grille section on them though that I thought could be used as a nice cold […]
I had already bought a set of rear discs and pads when I bought the set for the front from Godspeed. I didn’t fit the rears at the time I did the fronts as there was a decent amount of life left in the pads. Now it was time to fit the Godspeed G Hook […]
Having trial fitted the Rota Grid Drift wheels I was happy I wanted to fit them properly. The first thing to do was to fit some longer studs on the front due to needing 5mm spacers for the wheels to clear the Brembo calipers. I boought a set of these Hardrace studs. Time to get […]
The left fog light cover could do with a new decal and a little freshen up with a layer of lacquer so I carefully measured the dimensions of the original STI decals and had an eBay seller make me some exact copies of them for me. I wanted to make sure I placed the new […]
Having found myself a fairly recent Japanese import Forester STI. I wanted to give the underside the best chance of surviving UK winter roads as I could. Leaving it with no protection as it came from Japan was not an option. Too many newly imported cars are given a quick and cheap spray over the […]
With the Dinitrol Super Protect 447 applied, next I could deal with protecting the body shell and subframe cavities. I could also apply a layer of wax to the whole underside. There wouldn’t be much point in me putting in all this time and effort to protect the outer surfaces of the body shell and […]
So the underside of the Forester has been cleaned, stripped of bits of trim and some suspension and anything I didn’t remove that I don’t want to spray has been masked. It’s finally time to start spraying the Dinitrol Protect Super 447 Anti Stonechip layer. But before I got started I took some pictures of […]
I think it might be finished or at least as finished as any project can be. I had a bit of a move around of gauges inside. I found having the wideband gauge low down a bit of a problem when trying to catch a look at it to keep an eye on fueling while […]