As spring was on it’s way and the Elise would soon be allowed out of the garage again it was time to get some fresh oil in the engine and a new oil filter on. Oil, filter and sump plug washers. I had already removed the filter for better access when replacing the exhaust manifold […]
exige
S1 Elise – Clutch Slave Cylinder Support Bracket
When I was buying all the suspension refresh bits, for some reason I decided to buy one of these. An Elise Parts clutch slave cylinder support bracket. Apparently the original bracket can be a bit weak and bendy. I figured I’d may as well fit it while I had the air filter out the way. […]
S1 Elise – Suspension Refresh – Assembling the Rear Suspension
With the front finished it’s time to start assembling rear suspension components back onto the Elise. Pretty much the same as the front with a few small differences. Starting with these chassis brackets for the lower wishbones. A bit of corrosion block grease applied too. Right hand lower wishbone on. Upper one on. Damper mount. […]
S1 Elise – Suspension Refresh – Fitting Front Hub Carriers, Camber Shims, Ball Joint Plinths, Steering Arms, Brakes, Disc Guards and Drop Links
Now the wishbones are on and the bolts all torqued up… …I moved on to assembling the rest of the front end. As usual with these things ‘refitting is the reverse of removal’. The ball joint plinths need fitting to the ball joints first. I used a bit of copper grease here to help prevent […]
S1 Elise – Suspension Refresh – Fitting Front Wishbones and Shims for Maximum Caster
Having read a little about Elise wheel alignment it sounds like the best thing to do is to get as much caster angle into the front hubs as possible. More caster angle means increased weight and ‘feel’ in the steering and should increase grip at the front when cornering. The available caster adjustment on an […]
S1 Elise – Suspension Refresh – Fitting Elise Parts Nylatron Anti Roll Bar Bushes
While I had the rest of the suspension apart I figured I may as well replace the 20 year old rubber anti roll bar bushes with something a little better. So as I was already ordering a list of parts from EliseParts.com I went for some of their Nylatron ARB bushes. The bushes and grease […]
S1 Elise – Suspension Refresh – Fitting Caliper Brackets and Pressing in Drive Flanges
Just a couple of bits to assemble before parts go back on the car. The rear caliper brackets need to be fitted to the hub carriers before the drive flanges can be pressed into the bearings. This is because access to the allen head bolts is restricted when the drive flange is in place. With […]
S1 Elise – Removing and Refitting Headlamp Covers
The headlamp covers had been fitted with the usual sticky black butyl type adhesive so removing them wasn’t a big problem fortunately. It just requires a little bit of heat to soften it then once I had an edge lifted with my fingers the covers peeled off quite easily. Most of the adhesive was left […]
S1 Elise – Suspension Refresh – Fitting New Ball Joints
If you happen to have arrived here looking for info on how to replace a ball joint with the wishbone still on the car then check out my other post here. Having fitted the Elise Parts wishbone bearing kit I could move on to pressing the new ball joints in but just before getting stuck […]
S1 Elise – Suspension Refresh – Fitting New Wheel Bearings and Lacquering the Hub Carriers
After a few days wait my mate Steve turned up with a box for me. 🙂 I’m really happy with the colour, it ties in nicely with the original red seats in the car and means they will stand out a little under the car. Though nobody else is likely to ever see them I […]