My Elise came with an OMP steering wheel, fitted by a previous owner. The original Lotus wheel came with the car too but I like this OMP one so have kept it. The only thing I didn’t like was the noise it made when turning the wheel. It wasn’t noticeable in normal driving but when […]
lotus elise
S1 Elise – Clean and Wax
After a few days and a good few miles covered on our trip to the Lotus factory and around Norfolk the Elise looked OK from a distance as the weather had been good for the whole trip. But it was pretty grubby plus I wanted to get some wax on it so time for another […]
S1 Elise – Norfolk Road Trip and Lotus Factory Tour
Jem and I wanted to go for a long weekend away now the weather was nice and the Elise really deserved a road trip as the suspension refresh was all finished. We weren’t quite sure where to go, the Scottish Highlands are usually top of the list as it’s so quiet there and the roads […]
S1 Elise – A Quick Polish and Detail Before a Road Trip
We planned a little road trip for the Elise but first it would need a little cosmetic preparation. Some no nonsense Autoglym Super Resin to give the paint a light freshen up and a little protection. Clearly removing a little bit of grime built up on the paint. Super Resin applied. Buffed off to a […]
S1 Elise – Suspension Refresh – Initial Geometry Alignment
Now the the Elise was back together, after a complete suspension refresh, it would need a wheel alignment check. I was pretty careful about setting everything up during reassembly so that hopefully everything would be about right but it still had to be checked and the front and rear toe would certainly need some adjustment. […]
S1 Elise – Suspension Refresh – Assembling the Rear Suspension
With the front finished it’s time to start assembling rear suspension components back onto the Elise. Pretty much the same as the front with a few small differences. Starting with these chassis brackets for the lower wishbones. A bit of corrosion block grease applied too. Right hand lower wishbone on. Upper one on. Damper mount. […]
S1 Elise – Suspension Refresh – Fitting Front Wishbones and Shims for Maximum Caster
Having read a little about Elise wheel alignment it sounds like the best thing to do is to get as much caster angle into the front hubs as possible. More caster angle means increased weight and ‘feel’ in the steering and should increase grip at the front when cornering. The available caster adjustment on an […]
S1 Elise – Suspension Refresh – Fitting Elise Parts Nylatron Anti Roll Bar Bushes
While I had the rest of the suspension apart I figured I may as well replace the 20 year old rubber anti roll bar bushes with something a little better. So as I was already ordering a list of parts from EliseParts.com I went for some of their Nylatron ARB bushes. The bushes and grease […]
S1 Elise – Suspension Refresh – Preparing All Parts for Reassembly
After a lot of dismantling, cleaning, painting and a bit of assembly of parts it’s finally time to start fitting parts back onto the Elise. There’s quite a few parts though which includes a fair number of nuts, bolts and washers. So first I took the time, with the help of my glamorous assistant, to […]
S1 Elise – Removing and Refitting Headlamp Covers
The headlamp covers had been fitted with the usual sticky black butyl type adhesive so removing them wasn’t a big problem fortunately. It just requires a little bit of heat to soften it then once I had an edge lifted with my fingers the covers peeled off quite easily. Most of the adhesive was left […]