Now the the Elise was back together, after a complete suspension refresh, it would need a wheel alignment check. I was pretty careful about setting everything up during reassembly so that hopefully everything would be about right but it still had to be checked and the front and rear toe would certainly need some adjustment. […]
I thought I’d take a few pictures of everything freshly reassembled after the suspension refresh, as a record of it’s condition, before I cover it all with ACF-50 and it ends up with a layer of brake dust and road grime over it. Now I can get the Elise back on it’s wheels! 🙂
With the front finished it’s time to start assembling rear suspension components back onto the Elise. Pretty much the same as the front with a few small differences. Starting with these chassis brackets for the lower wishbones. A bit of corrosion block grease applied too. Right hand lower wishbone on. Upper one on. Damper mount. […]
Just a couple of bits to assemble before parts go back on the car. The rear caliper brackets need to be fitted to the hub carriers before the drive flanges can be pressed into the bearings. This is because access to the allen head bolts is restricted when the drive flange is in place. With […]
Corrosion of the Elise/Exige/VX220/Evora chassis is a thing and it’s something that I think should not be ignored by anyone looking to buy one of these cars. Also anyone who owns one that’s done a fair bit of winter road miles or is just a good few years old now should consider inspecting their chassis […]
With all the preparation done. Finally it’s time to actually get some paint on these parts. Obviously the wishbones are a bit of an awkward thing to paint so I attached a bit of fishing line to each of them so I could hang them while painting and to dry. This was a great idea […]
As I said in my previous post I decided on using POR15 on the wishbones and other steel parts. The main reason I chose it was that I could do it all myself. I am also not a fan of powder coating which is one of the other common options. In my experience with powder […]