An important part of getting the most power out of the EJ255 in the Forester STI is improving exhaust flow. The factory catalytic converter (cat) is quite a restriction on flow and it being right at the outlet of the turbo will really reduce the speed the exhaust gas can flow through the exhaust turbine […]
The factory inlet to the air box draws air from just behind the headlight down into a Y piece with a large air box underneath then back up into the filter box. The STI fog light covers have a useful grille section on them though that I thought could be used as a nice cold […]
I’d already fitted some new, larger door speakers in the front doors as shown here. One of the rears had a bit of a rattle and they were likely to be in the same poor condition that I found the fronts in so may as well change them too. Off with a door card to […]
The wheels that were on the Forester when I bought it are proper GC-010E Prodrive/Bridgestone branded forged items made in the Rays factory in Japan. They’re quite a desirable wheel, look good and are about as light as a set of 18’s are going to get so they drive very well. Me being me though, […]
There was a bit of play in the gear change. To be honest it wasn’t too bad but I really hate feeling any slack in a cars controls so I took a look at the linkage to see if I could find anywhere with any slack and if I could do anything to tighten up […]
We planned a week away for a bit of driving on some nice roads but before we could go anywhere the Forester would have to look it’s best. While I had it up on the lift for a general, pre road trip, check over I gave the Genome exhaust a polish. Then out the garage […]