Now the the Elise was back together, after a complete suspension refresh, it would need a wheel alignment check. I was pretty careful about setting everything up during reassembly so that hopefully everything would be about right but it still had to be checked and the front and rear toe would certainly need some adjustment. […]
I thought I’d take a few pictures of everything freshly reassembled after the suspension refresh, as a record of it’s condition, before I cover it all with ACF-50 and it ends up with a layer of brake dust and road grime over it. Now I can get the Elise back on it’s wheels! 🙂
With the front finished it’s time to start assembling rear suspension components back onto the Elise. Pretty much the same as the front with a few small differences. Starting with these chassis brackets for the lower wishbones. A bit of corrosion block grease applied too. Right hand lower wishbone on. Upper one on. Damper mount. […]
After a lot of dismantling, cleaning, painting and a bit of assembly of parts it’s finally time to start fitting parts back onto the Elise. There’s quite a few parts though which includes a fair number of nuts, bolts and washers. So first I took the time, with the help of my glamorous assistant, to […]
If you happen to have arrived here looking for info on how to replace a ball joint with the wishbone still on the car then check out my other post here. Having fitted the Elise Parts wishbone bearing kit I could move on to pressing the new ball joints in but just before getting stuck […]
As I’ve shown in previous posts I’d removed any loose rust with various wire wheels and brushes and used the POR15 Cleaner Degreaser to thoroughly clean any grease and dirt off all surfaces. So the second stage of the process was to apply POR15 Metal Prep. This is what they say about their Metal Prep: […]